Search the Community

Hello, I have connected the AD2 to Spy on an existing SPI Bus between a STM Controller and an IC provided by our Company, and am trying to just spy and log the traffic for tool verification reasons. When i use the Setup with the Waveforms GUI, everything works fine. It displays all Samples, the data looks ok, everything fine. As soon as I start using the tool via API (Python or C#, happens on both) the SPI Phase Settings seems to get ignored. I get flipping Bits all over the place, which is the same behaviour as if i set the Phase in the Waveforms GUI (Waveforms -> Protocol -> SPI) to the wrong setting. The correct Setting for my application is polarity=0 and phase=1, so I used FDwfDigitalSpiModeSet with it's parameter set to 1. I attached the C# and Python programs below for reference, maybe i overlooked something in there, but wouldn't know what should be wrong with it... Program.cs spi_tracker.py

I am new with the waveform Digital Discovery 2. How is it possible to decode the data which comes from PIN DIO 13. I think it is easy for someone who knows the tool. If the signal changes I want to write in the custom script a wave which changes about my logic. Thanks

不确定这是正确的线程,只是the account to post this since I cannot find anyone having a similar issue. So I am trying to install Waveforms. I am running a 64 bit operating system with Windows 10. Basically everything seems fine until after install. Any time I try and run Waveforms it doesnt run and I get an error message that reads exactly as: "The code cannot proceed because VCRUNTIME140.dll was not found. Reinstalling the program may fix this problem." Issue is I have tried un-installing and re-installing around four times now, including just re-installing without uninstalling the original download. I found a thread on Digilent that had some .exe's for repairing/installing Visual C++ and I have tried those to no avail. This system error shows up three times as well, so I believe the program is trying to launch and is missing some kind of pre-requisite software but from what I can see I have everything. I am sure its a 64 bit operating system, I am sure its Windows 10, and I know that the AD2 is not the problem, as it is not plugged in and it was working fine on my buddies laptop. Please help, I need this to work on my Senior Project during the quarantine and having these installation problems has put me behind, does anyone know where I can find this .dll and where I would need to place it for the software to work properly? Cheers, Eric Bettencourt

Hello, I just installed waveforms on macOS to use it with an Analog Discovery 2 but when I try to launch the application I get the following message: Do you have any idea about what I can do to be able to run waveforms application? For information: macOS 10.15.4 waveforms_v3.12.2 (downloaded from the official website) EDIT: I just tried with the beta version v3.13.12 but I get the same message and the application does not start too.