Search the Community
显示结果标签“eepm”。
Found 4 results
-
Hi Everyone, Just accidentally flashed the EEPROM attached to the FT2232 device on the Arty. The board is dead without the USB connection. Been using for 2 months without issues until today. In Vivado it is showing: "ERROR: [Labtoolstcl 44-469] There is no current hw_target.". when trying to Auto Connect with the target in Hardware Manager. Within FT_Prog (FTDI's flash tool), the registers (e.g. serial number, vendor ID, D2XX/VCP driver ...) can all be read and modified. How can it be restored back to Digilent factory setting? Is there an FT_Prog template that we can use? Thanks, Robin
-
I ruined my JTAG-HS2 cable while I was trying to change the display name with FT_PROG sw from FTDI. Adept cannot find my cable any longer. How could I recover it? Many thanks. jo ----
-
Hi, I have lost firmware for Nexys 2 USB Controller (CY7C68013A-56) which is stored on 24AA128-EEPROM. I want to update it by CyConsole application. Could anybody help? Thanks
-
Hi, I'm following these steps: https://www.digikey.com/eewiki/display/LOGIC/Digilent+Arty+A7+with+Xilinx+Artix-7+Implementing+SiFive+FE310+RISC-V Ubuntu 18.04. Vivado 2019.2. Arty A7 35T. Olimex ARM-USB-OCD-H. Cables are placed correctly. Steps are correctly but the last doesn't work. But when I try to do the step Vivado Installing Configuration to Device, Vivado doesn't recognize my Arty. The drivers and lsusb: I think the problem is the FT2232 EEPROM, how can I restore it? Any help, please? That's all, if you need more information tell me. Thanks